Linux version 2.6.8.1-irqpoll (jim@neurosis) (gcc version 3.3.4 (Debian 1:3.3.4-6sarge1)) #1 Fri Oct 15 13:25:39 EDT 2004 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000ce000 - 00000000000d0000 (reserved) BIOS-e820: 00000000000dc000 - 00000000000e0000 (reserved) BIOS-e820: 00000000000e4000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000002f6f0000 (usable) BIOS-e820: 000000002f6f0000 - 000000002f6fc000 (ACPI data) BIOS-e820: 000000002f6fc000 - 000000002f700000 (ACPI NVS) BIOS-e820: 000000002f700000 - 000000002f780000 (usable) BIOS-e820: 000000002f780000 - 0000000030000000 (reserved) BIOS-e820: 00000000ff800000 - 00000000ffc00000 (reserved) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) 759MB LOWMEM available. DMI 2.3 present. Built 1 zonelists Kernel command line: root=/dev/hda1 ro console=ttyS0,115200n8 console=tty0 acpi=off Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Initializing CPU#0 PID hash table entries: 4096 (order 12: 32768 bytes) Detected 863.967 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 767092k/777728k available (1760k kernel code, 9816k reserved, 724k data, 140k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 1708.03 BogoMIPS Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: Intel Mobile Intel(R) Pentium(R) III CPU - M 866MHz stepping 04 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 863.0755 MHz. ..... host bus clock speed is 132.0885 MHz. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xfd9b2, last bus=1 PCI: Using configuration type 1 mtrr: v2.0 (20020519) ACPI: Subsystem revision 20040326 ACPI: Interpreter disabled. PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Transparent bridge - 0000:00:1e.0 PCI: Using IRQ router PIIX/ICH [8086/248c] at 0000:00:1f.0 PCI: IRQ 0 for device 0000:00:1f.1 doesn't match PIRQ mask - try pci=usepirqmask Machine check exception polling timer started. Initializing Cryptographic API Real Time Clock Driver v1.12 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A ttyS2 at I/O 0x3e8 (irq = 4) is a 16550A PCI: Found IRQ 9 for device 0000:00:1f.6 PCI: Sharing IRQ 9 with 0000:00:1f.3 PCI: Sharing IRQ 9 with 0000:00:1f.5 loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH3M: IDE controller at PCI slot 0000:00:1f.1 PCI: Enabling device 0000:00:1f.1 (0005 -> 0007) PCI: IRQ 0 for device 0000:00:1f.1 doesn't match PIRQ mask - try pci=usepirqmask PCI: Assigned IRQ 9 for device 0000:00:1f.1 ICH3M: chipset revision 2 ICH3M: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1840-0x1847, BIOS settings: hda:DMA, hdb:pio hda: HITACHI_DK23EA-30, ATA DISK drive Using anticipatory io scheduler ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide2: I/O resource 0x3EE-0x3EE not free. ide2: ports already in use, skipping probe hda: max request size: 128KiB hda: 58605120 sectors (30005 MB) w/2048KiB Cache, CHS=58140/16/63, UDMA(100) hda: hda1 hda2 mice: PS/2 mouse device common for all mice input: PC Speaker i8042.c: Detected active multiplexing controller, rev 1.1. serio: i8042 AUX0 port at 0x60,0x64 irq 12 serio: i8042 AUX1 port at 0x60,0x64 irq 12 serio: i8042 AUX2 port at 0x60,0x64 irq 12 serio: i8042 AUX3 port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 input: AT Translated Set 2 keyboard on isa0060/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 8192 buckets, 64Kbytes TCP: Hash tables configured (established 262144 bind 65536) IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 ReiserFS: hda1: found reiserfs format "3.6" with standard journal ReiserFS: hda1: using ordered data mode ReiserFS: hda1: journal params: device hda1, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda1: checking transaction log (hda1) ReiserFS: hda1: replayed 6 transactions in 2 seconds ReiserFS: hda1: Using r5 hash to sort names VFS: Mounted root (reiserfs filesystem) readonly. Freeing unused kernel memory: 140k freed Adding 982288k swap on /dev/hda2. Priority:-1 extents:1 input: PS/2 Generic Mouse on isa0060/serio4 md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 Linux agpgart interface v0.100 (c) Dave Jones 8139too Fast Ethernet driver 0.9.27 PCI: Found IRQ 9 for device 0000:01:01.0 PCI: Sharing IRQ 9 with 0000:01:04.0 eth0: RealTek RTL8139 at 0xf012a000, 00:d0:59:46:18:a5, IRQ 9 agpgart: Detected an Intel 830M Chipset. agpgart: Maximum main memory to use for agp memory: 682M agpgart: Detected 8060K stolen memory. agpgart: AGP aperture is 128M @ 0xe8000000 usbcore: registered new driver usbfs usbcore: registered new driver hub USB Universal Host Controller Interface driver v2.2 PCI: Found IRQ 9 for device 0000:00:1d.0 PCI: Sharing IRQ 9 with 0000:00:02.0 uhci_hcd 0000:00:1d.0: Intel Corp. 82801CA/CAM USB (Hub #1) irq 9: nobody cared! [] __report_bad_irq+0x2a/0x90 [] note_interrupt+0x81/0x110 [] do_IRQ+0x128/0x140 [] common_interrupt+0x18/0x20 [] packet_release+0x6b/0x140 [] __do_softirq+0x2e/0x80 [] do_softirq+0x27/0x30 [] do_IRQ+0xfa/0x140 [] common_interrupt+0x18/0x20 [] setup_irq+0x7f/0xf0 [] usb_hcd_irq+0x0/0x70 [usbcore] [] request_irq+0x84/0xd0 [] usb_hcd_pci_probe+0x1f2/0x500 [usbcore] [] usb_hcd_irq+0x0/0x70 [usbcore] [] bad_pipe_w+0x9/0x10 [] pci_device_probe_static+0x52/0x70 [] __pci_device_probe+0x3c/0x50 [] pci_device_probe+0x2c/0x50 [] bus_match+0x3f/0x70 [] driver_attach+0x5c/0xa0 [] bus_add_driver+0x91/0xb0 [] driver_register+0x2f/0x40 [] pci_register_driver+0x5c/0x90 [] uhci_hcd_init+0xc2/0x141 [uhci_hcd] [] sys_init_module+0x119/0x230 [] syscall_call+0x7/0xb handlers: [] (usb_hcd_irq+0x0/0x70 [usbcore]) Disabling IRQ #9 uhci_hcd 0000:00:1d.0: irq 9, io base 00001800 uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected PCI: Found IRQ 9 for device 0000:00:1d.1 uhci_hcd 0000:00:1d.1: Intel Corp. 82801CA/CAM USB (Hub #2) uhci_hcd 0000:00:1d.1: irq 9, io base 00001820 uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 2 hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected hw_random: RNG not detected PCI: Found IRQ 9 for device 0000:00:1f.5 PCI: Sharing IRQ 9 with 0000:00:1f.3 PCI: Sharing IRQ 9 with 0000:00:1f.6 intel8x0_measure_ac97_clock: measured 49443 usecs intel8x0: clocking to 48000 PCI: Found IRQ 9 for device 0000:00:1f.6 PCI: Sharing IRQ 9 with 0000:00:1f.3 PCI: Sharing IRQ 9 with 0000:00:1f.5 airo: Probing for PCI adapters PCI: Found IRQ 9 for device 0000:01:04.0 PCI: Sharing IRQ 9 with 0000:01:01.0 airo: MAC enabled eth1 0:2:8a:dd:d6:5e airo: Finished probing for PCI adapters Linux Kernel Card Services options: [pci] [cardbus] [pm] PCI: Found IRQ 9 for device 0000:01:05.0 Yenta: CardBus bridge found at 0000:01:05.0 [10f7:8338] Yenta: ISA IRQ mask 0x0cb8, PCI irq 9 Socket status: 30000006 cs: IO port probe 0x0100-0x04ff: excluding 0x360-0x367 0x378-0x37f 0x4d0-0x4d7 cs: IO port probe 0x0800-0x08ff: clean. cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0a00-0x0aff: clean. NET: Registered protocol family 10